Page 1 of 1
Dana Reed's industrial size dubbing rake (DIY project)
Posted: Sun Feb 03, 2019 12:32 pm
by letumgo
Dana showed me a dubbing rake he made out of an old paint brush handle, and the cutter blade from an empty roll of packing tape.
Top Side
Bottom Side (sharp working edge)
Re: Dana Reed's industrial size dubbing rake (DIY project)
Posted: Sun Feb 03, 2019 3:07 pm
by daringduffer
Clever! I bet it will give him 100 bucks on eBay! Sign it first.
dd
Re: Dana Reed's industrial size dubbing rake (DIY project)
Posted: Sun Feb 03, 2019 8:34 pm
by Theroe
Re: Dana Reed's industrial size dubbing rake (DIY project)
Posted: Mon Feb 04, 2019 10:04 am
by REE04419
A friend used to make them out of pieces of hacksaw blades. Using various TPI (Teeth Per Inch) determined how much guard hair you got in the mix. He just cut a slot in a dowel, glued in the hacksaw blade section and he was done. They worked very well.
